Band Saw Table Inserts

I need insert for Rigid 14” band saw. Which one fits.

With a few exceptions, TI1 is the insert for a Rigid 14" bandsaw. If you measure it should be a 2-1/2" diameter hole.

https://www.woodline.com/products/band-saw-table-inserts?_pos=1&_sid=56378f1a7&_ss=r&variant=5678617537

Do you make table inserts for Rikon 14 inch bandsaw

TI-5 fits the Rikon 14" with 111" blade.

Do you have an insert for a JBS 20 bandsaw? Looks like it is a 2-3/4 OD. I have tried 3 different online sources and all were too small.

We have Ti-6 which is  2.72" OD x 2.4" ID x 0.11" lip thickness and 2.725" and Ti-7 2.725" OD x 2.25" ID x 0.15" lip thickness.

If neither of these work we can make a custom for you. Cost is $19.99 for set of three. We will need OD x ID x lip thickness. Along with model number and blade length of saw. If you have an original you can send us that and we can take measurement for you.

in need an insert for a powermatic pm2013b, 3 inches

Send the dimensions to [email protected] We will need overall diameter and thickness of the lip it sits on and we will see if we have one that size in our one-off file. Also give us name and model of the bandsaw.
If we have to make it from stratch there's a $24.00 fee for set of 3.

I have a grizzly 16" bandsaw and a Ridgid 14" bandsaw and they both need inserts that are 2-7" outside diameter. The TI1 that you sent are just a little too large. Can I return them for the correct size? Thanks

We do not make that size. It could go through custom shop. If you have an original we can use it to make you some. Cost for this service is $40 for set of 3.

i need a i.5 inch bandsaw table insert

Send the dimensions to [email protected] We will need overall diameter and thickness of the lip it sits on and we will see if we have one that size in our one-off file. Also give us name and model of the bandsaw.
If we have to make it from stratch there's a $24.00 fee for set of 3.