Our high-performance solid carbide spirals are engineered to provide the finest finish cut possible. This design allows for rapid chip removal and a chip breaker for plunging capabilities. ALL ARE TWO FLUTE UNLESS OTHERWISE NOTED.
NOTE: Due to the fragile nature, solid carbide bits are NOT warranted against breakage.
SOLID CARBIDE UPCUT SPIRAL ROUTER BITS
QUESTIONS & ANSWERS
Ask a Question-
Where are these bits made?
Woodline spirals are US made. CMT spirals are made in Italy. Amana spirals are made in Israel and the US.
-
What is the overall length of the WL-1002sES router bit
It is 2½".
-
Is triple flute preferred on a 2.5" upcut spiral carbied bit?
It all depends on the application. If it is CNC use, it will leave you with a cleaner cut than a two flute. In a handheld or router table use, it will only be marginally better due to the lack of feed rate. The 3 flutes get hotter quicker meaning you need to increase your feed rate in order to get the maximum benefit of the bit. You will also wear 3 flutes out quickly if this is not accomplished.
-
I am looking for 1/16” diameter cutting width, with a 1/8” or 1/4” shank. Uncut spiral. Do you sell this size?
Check out this bit. It should work for you. https://www.woodline.com/products/plastic-cnc-spiral-o-flute
DID A GREAT JOB
The bits performed an awesome job
Thanks for sharing your outstanding work.
Works fantastic !!
great service
Very sharp - Clears vhips well
