Our high-performance solid carbide spirals are engineered to provide the finest finish cut possible. This design allows for rapid chip removal and a chip breaker for plunging capabilities. ALL ARE TWO FLUTE UNLESS OTHERWISE NOTED.
NOTE: Due to the fragile nature, solid carbide bits are NOT warranted against breakage.
SOLID CARBIDE UPCUT SPIRAL ROUTER BITS
QUESTIONS & ANSWERSAsk a Question
Where are these bits made?
Woodline spirals are US made. CMT spirals are made in Italy. Amana spirals are made in Israel and the US.
What is the overall length of the WL-1002sES router bit
It is 2½".
Is triple flute preferred on a 2.5" upcut spiral carbied bit?
It all depends on the application. If it is CNC use, it will leave you with a cleaner cut than a two flute. In a handheld or router table use, it will only be marginally better due to the lack of feed rate. The 3 flutes get hotter quicker meaning you need to increase your feed rate in order to get the maximum benefit of the bit. You will also wear 3 flutes out quickly if this is not accomplished.
I am looking for 1/16” diameter cutting width, with a 1/8” or 1/4” shank. Uncut spiral. Do you sell this size?
Check out this bit. It should work for you. https://www.woodline.com/products/plastic-cnc-spiral-o-flute